home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
HAM Radio 3.2
/
Ham Radio Version 3.2 (Chestnut CD-ROMs)(1993).ISO
/
mods
/
newmods3
/
alr72t
next >
Wrap
Text File
|
1991-03-10
|
2KB
|
52 lines
ALR72T
EXTENDED FREQUENCY RX AND TX OF THE ALR72T & ALR72HT
ALINCO 70 CENTIMETER RADIOS.
BEWARE OF ANY STATIC WHEN WORKING WITH THIS RADIO !!!
1 Remove the top and bottom covers of the radio.
2 Remove the 4 screws that hold the front panel assembly to the main
chassis.
3 Pull front panel away from the main chassis very gently.
4 Locate the Volume\Squelch pot on the left side of the radio.
5 Locate the VFO control on the left side of the radio.
6 Between the two above units is an IC that runs vertically between
the two units. (ONLY THE 12 PINS OF THE IC ARE SEEN FROM THE BACK)
7 After locating the IC locate 3 sets of unsoldered jumper pads between
the IC pins.
8 Make a solder bridge between the top 2 pads,then the middle 2 pads,then
between the bottom 2 ONLY of the bottom set of 3 pads.
REAR VIEW OF FRONT PANEL
/ ------\ 12 PIN O * O /---------\
/ VOLUME \ IC -> |<-SOLDER BRIDGE / \
/ CONTROL \ O * O / \
/ \ / VFO \
\ / O * O \ CONTROL /
\ / |<-SOLDER BRIDGE \ /
\-----/ O * O \--------/
O * O
* DO NOT SOLDER THE TOP PAD
O |< O OF THESE 3 PADS
* \SOLDER BRIDGE HERE
9 RE-ASSEMBLE RADIO .
10 RESET MICROPROCESSOR.
GOOD LUCK AND HAPPY MODING 73 CARL VE3ZCO@VE3GYQ
CARL@HAMSTER.UWO.BUSINESS.CA.NA [129.100.22.100]
CARL VE3ZCO [44.135.80.8]